Activity Stream

All sorted. Let me know if you need more. Regards.

Hi Bladevane! Would you be able to add me to the drop box as well? Larsson365 AT live.se Best regards

Added DRO to the XYZ axis. Here is a video about my solution. If anyone is interested I can share the Arduino file.

it sure is possible in fact if you check amazon you can find a couple different lasers and also a 3018 kit that comes with both a wanna b spindle and...

Hi have you set your vref properly? (the tiny potentiometer on the back of stepper driver) is the stepper motor getting hot before blowing? check...

I agree. It has quickly become my most used saw. I use it for everything, both metal and wood. It is very versatile, simple to set it up and quickly...

Hi Nicolas welcome to the community!

Welcome to the Forum

I have one too and for the money it's a game changer.

Nice! Enjoy with your tools/machines.

Welcome to the forum.

Welcome.

That's a bit awkward, Could be done in two pieces and then welded into the assembly, best option would be wire EDM. Have a look on you tube,...

That's interesting as most of the teardown videos I have watched on Chinese spindles of machines like the Precision Mathews PM30 etc all have had...

Angular contact bearings are the most common bearings in spindles. You might get away with repacking the bearings, however if they've been heated...

If the slots need square corners, then they'll need some form of slotting or broaching. That could be achieved in a mill or a lathe with a...

Ok that's great, thanks again. I don't think I will use any DI's or DO's at the moment, just to keep it simple. after I've wired the Limits,...

I've only ever used the Servo Ready, and Fault DOs, however the only one you probably really need is the Fault output (or possibly just the Ready...

Thanks, m_c. That helps a lot, so I guess I was overthinking this. I'll wire the Limits/ E-Stop as I did before through the AXBB-E Controller. Would...

The servo drive limit input is for if you need the limit switch connected to the servo, which for CNC applications I can't think of any reason that...

If it's just to make uploading easier, a USB floppy disk emulator might be an option, such as -...

Well, there appears to be little information online as to what the control software is or what computer it runs on so it will be very hard to advise...

I need to install USB port for upload program. At the moment I'm using Floppy disk for upload program.

XYZ axis complete!

What are you hoping for?

Hi Chaz, I can do that - once I have recovered from a sudden bout of food poisoning! Basically everything is there with the exception of the power...