Activity Stream

Sold

Hi and welcome to the forum :encouragement:

There are a few DIY builds that have done this, but not many. Some of the biggest CNC Mills use this design ...

Just logged in to update this and realised it has been just over a year since I started the build… Work got in the way for a good while but I am back...

Quite often the forum software doesn't highlight new posts, and although you joined 2 days ago, it's only just popped up on my "Trending Now" list. ...

Could be the parallel port on the pc has gone then. I would get a voltmeter onto the bob. Put the +ve end on pc5v, put the -ve end on the dir pin. ...

Hi thanks for your reply, I'm not sure what the cost would be for digitising, it could end up quite costly, is there an ISBN number on the book so I...

Hi I now have a new lead and as before the Y axis only moves in one direction? If I chane position on bob then it is OK. I have spent alot of...

I've got one. I could digitise as a PDF and send it to you at your cost. I'd need to get a price locally. Let me know.

Have you had any joy - im desperate for someone to help me with my SPARTAN 1325

Hi Guys, Dont know if this nis how a forum works :S - first time for everything.. We have a Spartan 1325 CNC - supplied by radecal.. the...

Got the frame as level as possible and poured the epoxy this weekend: Overall I'm very happy with it, there's only one area I can...

Hi Danny, thanks for your input, I did pretty much what you suggested. I purchased a couple of moving skates for the rear of the CNC and one with 3...

....

Finally got some time with this. Homing is now working.just need to fine tune it. I managed to blow the relay side of the control board(Bob) messing...

Depends on your step servo dimensions you can fit inside, in my case I managed to fit inside original extrusion, just you need to order some original...

To me it sounds like the controller is hanging waiting for something to happen (and pretty rubbish programming, in that it locks up rather than...

.

Update: I removed the stepper motor and tried moving it unloaded - same problem SIEG gave me some further tests to put the software in debug mode...

Dear Phill05: Congratulations - Beautiful design and implementation - You are an accomplished machinist! Arquibaldo

Thanks for the offer, sadly due to eyesight problems, no longer intersted.

One of the wires goes in and out of COM/NC on the side that gets switched. Example: 220v+ve goes from feed+ to the pump 220v+ve. 220v-ve goes...

So am I right if I connect Bule on attached to P16 and P17 then red to pc5v?? were does the 220v come fromto drive the pump? I take it that the two...