Activity Stream

As magicniner says, the manufacturer is the first place to ask, followed by the bearing manufacturer. However, the general process will involve...

That sounds good, i've been trying to find a picture of the part in question but not got one yet. I need the vertical face to be way back where...

Ok 1 more thought.... The 90° bend casting has a flat verticall face. This woumd make a good solid mount for anyrhing you could bolt to it. And if...

I Googled Trespa, it's a manufacturer which makes several products. Have you asked them for recommended feeds & speeds for the specific Trespa...

Hi Magiciner thanx for bumping this one. Ok ... so i need to open it up.. it is a typical china spindle. I ran it a few times with no load at...

Thanks, thats an interesting thought. Not sure it will get me where i want to be fully though as the head still uses a quill so has the usual splines...

Machine model? Many OEM spindles have recommended Warm Up routines, doesn't your manufacturer have any recommendations? If you can find out...

Bump!!!!

Hi Thanks for the reply please could you give me a call. I am trying to find out about the lathes any info will be most welcome. my email:-...

Nice build, following with interest, I am also doing an epoxy build. The laser cut moulds look very neat. Have you decided on your epoxy % and...

Just to throw you a slight curve ball, I have a manual series 1 that I fully stripped and rebuilt a few years back, so I an very familiar with it....

Hi Rob, yes i have had a few 240's. Pm me and we can have a chat.

I agree. Well done.

This doesn't look like home made machine. I am speechless, attention to details and general looks blowing my mind - hats off

Hi I hope you may be able to help me!. I am thinking of getting a Boxford 240 tcl would you know who give me some abvice and anyone who could...

Bingo! If you can afford the fees for a Haas, go for it. From a perspective of someone that has to deal with this question from the sales side,...

Thanks Andy :) We're using a Creality CR10-S. Was printing accurately with PLA within an hour of opening the box - very pleased with it so far. ...

You still need the rigidity to machine them, which was my point the rigidity is there to do the work just not fast enough to make money in a...

You missed, "On a good day, with a following wind, if they're lucky and not for long" out of that, the same or better is also true of cheaply...

Same G-code which I'd run before without problems. Good thought about the G61, hmm well anythings possible. I'll have a look today.

I don’t think there is such a thing as a VMC with similar envelope? There are the XYZ 500/560’s that you could count. Haas have their mini mill which...

John, Thanks for the info. I've sent you an email.

check out our youtube channel. we video all of our repairs for our customers. we want you to know that your boards are repaired and working ...

We are just here to help with some issues that Haas customers have been dealing with and we have some solutions, such as processor board repair. We...

You hadn't inadvertently enabled exact stop (G61) mode? And was the G-code code you have run before without problems?

I watched that video a while ago, and it certainly confirmed a few suspicions I had. The other thing it highlighted were the NYCNC bias when...