Activity Stream

No, the machine's Rapid velocity is set at 10,000mm/min, in testing it reached over double this but we throttle it back to keep things sensible....

Oh, my poor little machine.!! . . . Did I mention the warranty was 12mths or 3.5million lines of code or whichever comes first..:hysterical: 38hrs...

Sure was the PC. After an hour of loading and then 4 hours of not responding I bailed. My decent pc did the whole calculation in 20 seconds. I do...

The motors look fine. I have almost identical on mine. However. I had to run my nema24's on 60vdc and my nema34 is a bit junk on 60v and is crying...

Jack_, all sorted. You should be added. Regards.

pm sent

Have sent PM

How much ? ect and thanks

OK will try to get it machined this weekend

Yes there is room for the radiused sides, and the damage was to the plastic part holing the bearings in place. I have tried without success to...

Nut would appear to be similar apart from the radiused sides, is there room for this . What is the damage to the screw, can't see any in the pics ...

Sent a PM Walter

Good that it was 'just' the PC and not an AXBB-E/UCCNC limitation. Kit

This time - machining the main front plate . . .

trying to upload to here,, wont work is there a file size limit?https://flic.kr/s/aHsmVcSX4L loaded to google and flikr not sure which would be...

overall length is 145mm 8mm at the lower section to fit the bearing, the top section is also 8mm and 20mm long, the flange is square 8mm thick ( I...

Hi Is there no thread involved,is 145mm the thread length or the O/A length. Will the nut fit, my nut is 35mm O/A, the flange is 8mm thk x 40 dia....

It seems that there is now a respectable upgrade to the workbee which is called Queenbee with linear rails and strengthen aluminium profile making it...

thats an amazing offer thankyou .. the total length is 145mm top diameter 8mm x 20mm bottom 8mm x8mm would that work for you and how much...

I presume that you would also need a thread and a reduction for your coupling, if you can provide details, I have a lathe

Another family commission! Just need to break into the real world! Set of 8 placemats for the in-laws. Over complicated, over engineered but a...

Yes. I spotted that. Just an error in setting the time calc. Machine is set for 3000mm/min.

I need one end to fit 8mm bearing so would need it machined and I dont yet have a lathe.... other wise would have got that from you.. but thanks for...

Andy, Ok thank you for that information.

Before you go too far it might be a useful exercise to go through all the parameters you have set for the machine.I seriously doubt you will be...

All sorted. Had to wheel out the big gun for this - a core2 duo with 4gb ram doesn’t cut the mustard.... new cnc pc is needed.

I have a spare 1204, 300 mm long not machined if any use I have used the supplier that Lee mentioned quite successfuly

It's a very old post, but If you still follow the responses.... The choice to get answer if you ask the seller.