Activity Stream

Fantastic

I have posted a wanted ad, but my question was not about that.

What sized router do you want? What budget do you have? Home or semi pro it's better to post a wanted.

Have requested this before but no improvement. It is really annoying.

The new antex is chinese and the first batch were duff!! A lot of chinese products are crap but there are some good one's. It's a lottery as to what...

Next time buy the Chinese one i bought. No problems so far. :applause:

Hi Cropwell Send it back to them and they will most likely stand by thier product and send you a replacement. I've been using antex irons for 40...

I don't expect a new one from Antex, this one was two years old and I attempted to repair it. Still, a reel of solder would be a nice token gesture.

Antex had a load of problems with the tcs 50 irons (Chinese made) Luckily they honour their guarantee and send replacements. I had 2 go south one...

Yes,take a look at his help and videos, its quite an easy program, just sometimes too easy.

Well I've not posted for a while and now i think i'm finally finished! Got rid of the masking tape holding various wires and also 3d printed some...

I know this is an old thread, but the Antex TCS50 I ordered in August 2016 has just gone bang in my hand. The silicone cable flexes too much near the...

As a 3 axis its working fine and its happily just cut out this large map in 18mm birch for a client. Phew Haven't atached the cross bracing across...

Hi no problem thanks for getting back. I have posted the details of my cnc I hope I can get some informative replies on upgrading and setting up the...

Me? Sarcastic? Probably. I was trying to explain why you were getting no replies :eagerness:

Hello Toninox I will get the settings recorded and will post them for you. Regards Barrie

Plyonracer, could you please share mach3 parameters? i really can't configure it if someone need i can share the milling sofware v4 rev. 6 of...

Yes, motor Delta, wired my friend's 300 to use all the standard controls, just with a speed pot added, Fwd/Rev lever works as standard as does the...

The controller is connected via a USB to the pc. I generate the designs via Aspire V carve save it then open the file in the proprietery software...

The motor is bolted to the the headstock but the drive is via belts and it's spinning a big old chuck so may not be too bad. I'll face off some...

If its running something proprietary, why not move to something like Acorn centroid or does the current control system do a lot of the CAD / CAM for...

Hi yes that was the post. The cnc 3 years old and very well made it has a 1 x 2 meter bed 200mm gantry height, it is 440volt, it will soon have...

Ah, I think you posted before, I remember the machine and the vid. Are you looking for someone to fix the current control setup or potentially...

It has a polish made controller PIKO that has a dedicated software. http://www.pikocnc.com/download-1 The cnc is a Polish built machine is CREBER...

Almost ;-) Myford Super 7 Long Bed, 1hp, 3 phase, at 2000rpm and 0.2mm DOC, manual feed so the material comes off like angel's hair on fire...

Interesting result. Is the original bit of machining as rough as it looks? I know that photographs are often misleading when it comes to surface...

Hi Ravi Sorry for not replying sooner but have been busy machining parts for my gas turbine. I see you have carried out some serious mods to your...