Activity Stream
-
Older Activity
-
20 Hours AgoStarting the enclosure for the knee lift electronics. I seem to like making it complicated!100 replies | 158567 view(s)
-
3 Days AgoWhat are you struggling with?4 replies | 568 view(s)
-
3 Days AgoJohnHaine replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member Introductions...or there!4 replies | 568 view(s)
-
3 Days AgoJohnHaine replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member Introductionshttps://www.forum.cncdrive.com/ Maybe more likely to find help here.4 replies | 568 view(s)
-
3 Days AgoBeen using my home built cnc mill router for years now for personal use. Its getting a bit worn and after being shipped with our belongings from...0 replies | 270 view(s)
-
3 Days AgoI am looking for a little guidance on how to test my 3 phase spindle with a multimeter to see if there is an issue ,,, as it won't run ,just a slight...0 replies | 320 view(s)
-
4 Days AgoAhmad T replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member IntroductionsWelcome to the forum.4 replies | 568 view(s)
-
5 Days AgoHi All, Looking for some assistance to set up my Triac that I have had retro-fitted with UCCNC software. Any assistance would be much appreciated...4 replies | 568 view(s)
-
6 Days AgoPhil Mayor replied to a thread Testing The VFD, Break Resistor and Wiring to AXBBE in Spindles & Drive MotorsI think I'm going to try to return this VFD, I do think it's quite a good bit of kit, it's just the Chinglish that makes this a much harder job, I've...30 replies | 4591 view(s)
-
6 Days AgoI am running a fuling vfd which until today was fine , the spindle would not operate , trying to start but won't, i then noticed the spindle hz...0 replies | 390 view(s)
-
6 Days AgoPJMCAmbs started a thread FOR SALE: JET 22-44 Plus Drum Sander 240 Volt Axminster with Auto Feed in/Feed out Table. in Items For SaleIntroducing the JET 22-44 Plus Drum Sander, the perfect solution for all your woodworking needs. This high-quality sander boasts a powerful 240 Volt...0 replies | 458 view(s)
-
6 Days Agovoyager1972 replied to a thread touch probe connectivity with ceramic bearings in Machine DiscussionThanks for the reply , that makes things a lot clearer to me now , they operate different from a touch plate.12 replies | 1170 view(s)
metalworking pillar drill...