Activity Stream

No but quite a few people over on the Model engineer forum have.

That's interesting John. Have you used one?

Hi, trying to send you a private message but doesnt seem to be working. Will see if I can get it sorted.

Hello again, everyone Just leaving this here in case anybody, at any point in the future, finds it interesting I'm still looking / open to hear...

https://www.ebay.co.uk/itm/550W-Mute-Brushless-SERVO-Motor-for-Industrial-Sewing-Machinery-Energy-Saving/204015227615?_trkparms=amclksrc=ITM&aid=11100...

Μthings can be processed faster if you send me a copy of the bin file

Today machined the other 2 parts for the on-board probe assembly. Never had to do parts so small and with 3 side operations. Project is not...

It should be in series with the motor. The fact it's been disconnected would indicate there's been a problem. Depending on how much money you're...

THanks MC. How would that choke be wired? Is it in series like a resistor? It's not wired up at the moment.

This is really cool- thanks so much for sharing! Very inspiring

https://t.me/pump_upp - best crypto pumps on telegram Make 1000% and more within 1 day, join channel @pump_upp !

That looks off topic.

Is this gone?

Im sure you got that plywood sorted if not I would recommend reclaimed wood from www.audriniliving.com

That's a choke. They help smooth/suppress noise from the motor. It's worth checking it's not failed and gone open circuit (either with a...

No luck yet with the motor controller. It has 240v to it, I can measure 12v across pins 12 & 10. I attached a pot to 12 & 10 and 11 and can vary 11...

https://t.me/pump_upp - best crypto pumps on telegram Make 1000% and more within 1 day, join channel @pump_upp !

Hi, How much are you wanting?

3 motors no cables - i am using them on my new motors and drivers i could leave it all ready to run IF you vcan work out the inputs into the rs232...

Relayman So we are wondering if the fault with our system is the Dahlgreen. Could it be firmware? Or RAM memory? Our machine sometimes prints...

Good stuff, glad to help.

Pics of the three phase motors/controller ?

Recently just did this as per your and m_c's recommendation, couldn't be happier with how it worked out. Thanks so much.

Hello Digger is this still available? cheers ste