Activity Stream
-
Older Activity
-
10 Minutes Agohi , i have just mounted a new atc spindle to my router which is running fine , my issue is the setup of the manual tool change button ,i have two...0 replies | 0 view(s)
-
1 Hour Agohi , i have just mounted a new atc spindle to my router which is running fine , my issue is the setup of the manual tool change button ,i have two...0 replies | 12 view(s)
-
4 Hours Agograin_r replied to a thread NEW MEMBER: Hi all! Questions about DIY project in New Member IntroductionsHello Frank It looks like it is a standard Aluminium profile which could certainly be used to make the easel, although the stop blocks look a bit...2 replies | 601 view(s)
-
8 Hours AgoPhil Mayor replied to a thread Testing The VFD, Break Resistor and Wiring to AXBBE in Spindles & Drive MotorsThe supplier has just got back to me and suggested increasing the Break Resistor to a 1500w 75ohm type, but from my understanding a 75ohm would take...10 replies | 1817 view(s)
atc spindle