Activity Stream
-
Older Activity
-
46 Minutes AgoJust done a little bit of research. Looks like the Ooznest relies on prewired harnesses and a bunch of configuration files to set machine parameters....2 replies | 18 view(s)
-
1 Hour AgoTwo points to note before I suggest something: - I don't know the Ooznest hardware kit at all, so not sure how the stepper motor to driver...2 replies | 18 view(s)
-
3 Hours AgoHi all, I am completely new to everything related to the CNC world, having said that I have had a machine sitting in their boxes for some time now...2 replies | 18 view(s)
-
3 Hours AgoWelcome to MYCNCUK.1 replies | 140 view(s)
-
10 Hours AgoHi all, Thank you for allowing me to join this forum, My name is Mark and I live in a small village called Alfriston in East Sussex. I retired from...1 replies | 140 view(s)
-
1 Day AgoStarting the enclosure for the knee lift electronics. I seem to like making it complicated!100 replies | 158813 view(s)
-
3 Days AgoWhat are you struggling with?4 replies | 622 view(s)
-
3 Days AgoJohnHaine replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member Introductions...or there!4 replies | 622 view(s)
-
4 Days AgoJohnHaine replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member Introductionshttps://www.forum.cncdrive.com/ Maybe more likely to find help here.4 replies | 622 view(s)
-
4 Days AgoBeen using my home built cnc mill router for years now for personal use. Its getting a bit worn and after being shipped with our belongings from...0 replies | 366 view(s)
-
4 Days AgoI am looking for a little guidance on how to test my 3 phase spindle with a multimeter to see if there is an issue ,,, as it won't run ,just a slight...0 replies | 416 view(s)
-
5 Days AgoAhmad T replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member IntroductionsWelcome to the forum.4 replies | 622 view(s)
-
5 Days AgoHi All, Looking for some assistance to set up my Triac that I have had retro-fitted with UCCNC software. Any assistance would be much appreciated...4 replies | 622 view(s)
-
6 Days AgoPhil Mayor replied to a thread Testing The VFD, Break Resistor and Wiring to AXBBE in Spindles & Drive MotorsI think I'm going to try to return this VFD, I do think it's quite a good bit of kit, it's just the Chinglish that makes this a much harder job, I've...30 replies | 4649 view(s)
Ooznest WorkBee Machine build...