Activity Stream
-
Older Activity
-
19 Hours AgoHi Neale, I will try what you have suggested, seems to be the right way to go. Ooznest has been good but I think there is a communication breakdown....5 replies | 201 view(s)
-
1 Day AgoAs a quick sanity check, have you tried comparing cable colours between each of the axes? There is always the possibility that a cable connector is...5 replies | 201 view(s)
-
1 Day AgoLooked at that link, and will try that as a last resort but ty for it, really appreciate it5 replies | 201 view(s)
-
1 Day AgoJust done a little bit of research. Looks like the Ooznest relies on prewired harnesses and a bunch of configuration files to set machine parameters....5 replies | 201 view(s)
-
1 Day AgoTwo points to note before I suggest something: - I don't know the Ooznest hardware kit at all, so not sure how the stepper motor to driver...5 replies | 201 view(s)
-
1 Day AgoHi all, I am completely new to everything related to the CNC world, having said that I have had a machine sitting in their boxes for some time now...5 replies | 201 view(s)
-
1 Day AgoWelcome to MYCNCUK.1 replies | 249 view(s)
-
1 Day AgoHi all, Thank you for allowing me to join this forum, My name is Mark and I live in a small village called Alfriston in East Sussex. I retired from...1 replies | 249 view(s)
-
2 Days AgoStarting the enclosure for the knee lift electronics. I seem to like making it complicated!100 replies | 159078 view(s)
-
5 Days AgoWhat are you struggling with?4 replies | 697 view(s)
-
5 Days AgoJohnHaine replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member Introductions...or there!4 replies | 697 view(s)
-
5 Days AgoJohnHaine replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member Introductionshttps://www.forum.cncdrive.com/ Maybe more likely to find help here.4 replies | 697 view(s)
-
5 Days AgoBeen using my home built cnc mill router for years now for personal use. Its getting a bit worn and after being shipped with our belongings from...0 replies | 412 view(s)
-
5 Days AgoI am looking for a little guidance on how to test my 3 phase spindle with a multimeter to see if there is an issue ,,, as it won't run ,just a slight...0 replies | 467 view(s)
-
6 Days AgoAhmad T replied to a thread NEW MEMBER: Denford Triac converted to UCCNC in New Member IntroductionsWelcome to the forum.4 replies | 697 view(s)
Ooznest WorkBee Machine build...