Activity Stream

And therein lies your problem.!! . . . . you get what you pay for. Quality cost's money and I've found it's better to just lube up and take the pain...

thank you for your reply and advice

Hi Matt, Well that's a picture showing a Chinese machine in a Chinese factory and if I'm not mistaken it's on Ebay.? If I'm correct then it's spec'd...

ok i'll sort it

(Jazz - just tried sending PM but your inbox is full!)

As soon as I press run the VFD trips and E004 flashes up, I had a look at page 75 however it doesn't really mean much to me not being an electrician,...

Ah, sorry, I interpreted this as meaning you needed a different inverter. God luck with getting it working. Plenty of us use these 2.2KW water cooled...

Looks seriously serious! Make sure you have enough room to move around it while bending over and enough room to fit a screwdriver in all the places...

So. With all settings as delivered, you've pressed RUN, then pressed UP, and at that point you get the E004? (it's important to understand the...

Ok I've tried your suggestion, I'm now getting an E004 error message I have put all the settings back to their original settings and still has an...

Stand levelled on floor and machine craned ontop to check final position, needs to be moved out from the wall a bit so I can fit/service the...

Sorry but I did not check the size of OP's mill. As I now check the Amadeal website it seems that a lot of their machines have a 25 designation but...

Okay, so F0.03 is defaulted to '0'?, so that's keyboard input. What happens if you Press RUN then press the UP (/DOWN) buttons - that *should* change...

Hi Doddy, Thanks, I pressed the run button on the VFD then went to the "n" using func/data button the "run" led lights up but when I turn the pot...

Rather than playing with settings - following the logic that this was configured by OEM, it might be worthwhile investigating the behaviour of the...

deleted

Ok thanks, that is interesting, YM of HDPE is only 0.8, how much support did you have under it, or what was the clear span? I guess we are only...

Hi this was set at 2, I've tried both 0 & 1 still no joy :grumpy:

30mm HDPE makes a nice stable bed and you can cut a grid pattern to make it into a Vacuum bed. I bought a 10x5 sheet for £500 so if you get in touch...

Ok I've just looked at the manual and I remember the parameter that sorted my issues was F1.0 I can't remember what it's set too but this was the...

I would probably use one large piece as the bed, then a second piece as the sacrificial board.

A bit more research on different materials, Young's modulus (GPa): MDF 4 SRBP (paxolin/tufnol) 6.5

Thanks Jazzcnc, I was getting a bit confused by the previous guys replies as the inverter was still fitted and wired into the BOB in the machine when...

Thanks, I've attached a photograph of the nameplate from the inverter the manual was downloaded from another forum

Yes all these spindles are 3 phase and that's why they a run with a VFD which changes single phase to 3 phase. The VFD is correct. Dougie, these...

That dose not mean that they are correct but a lot of VFD's you can change the number of poles. I would have thought that it should run but not...

hmm strange, this was the original inverter/VFD and spindle that was delivered with the machine?

A quick Google of GDZ-23 suggests it's a 3 phase motor which will therefore need a different inverter.