View Full Version : Woodwork Discussion

  1. Ply or MDF
  2. Woodturning on CNC lathe
  3. Which MDF?
  4. wooden joints
  5. Dragon project (Oak coffee table)
  6. jionery using a cnc
  7. mdf vs. ply vs. HDPE
  8. Anyone making fitted kitchens?
  9. Routing with 25mm pine
  10. how am I going to pull this off?
  11. MDF or ply?
  12. Long shot question.. about shared workshops
  13. toy box help please
  14. Roundover finishing - what's causing this..?
  15. 3d carving oak
  16. bosch collets and bits
  17. Work hold down
  18. tree problems!
  19. Workholding - Propeller
  20. Is anyone interested in cutting dovetail joints?
  21. Wood suppliers
  22. 4mm MDF cutting on CNC...Advice please
  23. "Nib" removal on MDF cutouts edges
  24. Glue for Vacuum Press Veneer?
  25. Vacuum bed general questions
  26. Kitchen doors
  27. Chinese tooling
  28. wood supplier.
  29. Any timbers to avoid?
  30. MDF.. More or less teeth/flutes for a better finish ?
  31. how long should a bit last ?
  32. Double sided tape
  33. Double sided tape
  34. Tiny round over for edging
  35. What feed and speed for Oak
  36. Getting the most out of a plywood sheet.
  37. Feed Rates and cutters for wood panels
  38. Double side machine a small part
  39. Machining thin Balsa
  40. What type of bit to use
  41. Getting tear-out - need advice
  42. working with only low grade chipboard
  43. Suitable Wood CNC mills
  44. Alternative to tabs for work holding? Double-sided tap? 0.5mm thick, long tabs?
  45. I need Help I need to get a decent CNC machine don't have to much to spend
  46. Is this a good Laser cutter
  47. Work Holding Tape/glue
  48. I want to make the perfect laser cut
  49. Community Project: Fender Telecaster