PDA

View Full Version : NEW MEMBER: Not so new introduction



Rebekah_harper
08-07-2016, 02:27 AM
Hiya guys and gals,

I've snooped on this forum on and off.

Now I'm serious about getting started.

ive been learning fusion 360 and have been doing quite well.

currently I'm 3 years into 3D printing using auto desk inventor. I have a Facebook page called RC-Truck-Design where for the curious you can see the 1/14 scale truck cabs.

I've got a Boxzy machine which is a new machine.

am yet to actually use it as I'm still needing to understand feed rates.

hope to get some chips soon.

Becky

routercnc
08-07-2016, 10:57 PM
Hi Rebekah

Welcome to the forum
Fusion 360 is a great bit of software. I'm sure you've found it already but if not check out John on YouTube nyccnc for Fusion Friday hints and examples

Rebekah_harper
15-07-2016, 06:26 PM
Hiya routercnc,

I haven't come accross him so I will check him out. I've been watching Lars christiansen who does a great introduction to the software.

I am going to ask about feedrates in this forum as this is the only thing that weighs heavy on my mind.

regards

becky

routercnc
15-07-2016, 06:42 PM
Lars is good too. Great thing about John is the enthusiasm and the fact he shows things from a users point of view

Rebekah_harper
20-07-2016, 03:37 PM
have you got a link to his videos?

Clive S
20-07-2016, 04:57 PM
have you got a link to his videos?Is this you are looking for:- https://www.youtube.com/watch?v=AMh2TnfPsaY