PDA

View Full Version : Denford Triac - Help



mikeadams1985
02-08-2016, 09:51 PM
I tried to post in the intro section but my post never appeared.

I have the option to get my hands on the above machine.

I need the machine to cut out shapes in sheet metal. Usually tin or Aluminum bout 2mm thick.
Id like a machine that can do 3d carvings...Would this machine do this?
Im pretty new to all this jazz and if i can get this machine cheap i think it can do everything and more than i need.

Does anyone know what a second hand one should go for?
it doesnt come with a PC, but i assume i can hook it up to any old windows based PC and correct software?


this is the machine in question

https://cdn.globalauctionplatform.com/e10e462e-b2fc-4db1-bb78-a65200c03c9d/3bd03e9a-a094-45e5-b6d1-5102645f7316/original.jpg

Tommy
12-01-2017, 09:06 AM
I tried to post in the intro section but my post never appeared.

I have the option to get my hands on the above machine.

I need the machine to cut out shapes in sheet metal. Usually tin or Aluminum bout 2mm thick.
Id like a machine that can do 3d carvings...Would this machine do this?
Im pretty new to all this jazz and if i can get this machine cheap i think it can do everything and more than i need.

Does anyone know what a second hand one should go for?
it doesnt come with a PC, but i assume i can hook it up to any old windows based PC and correct software?


this is the machine in question

https://cdn.globalauctionplatform.com/e10e462e-b2fc-4db1-bb78-a65200c03c9d/3bd03e9a-a094-45e5-b6d1-5102645f7316/original.jpg

Hi, Do you have “baldor D281 motion control card for a Triac P. C. (denford), red 7-segment LED display type. The firmware is ESMINT 3.28 V1.6H/S - JD5.” Cheers.