PDA

View Full Version : Mach 3 Help



RichardR
03-08-2016, 06:02 PM
Having watched numerous utube clips and read as much as I can, about mach 3, I am having problems, I am a 67 year old and find I fall asleep when watching a screen and trying to read, plus by the time I get into the workshop I have forgotten what I have seen or read, by comparison once I have been shown how to do something then I am good to go, strange but true.
Is there anyone in the Minety area (near Swindon, Cirencester or Malmesbury) who would be willing to spend some time to show me the basics so I can get started?
Thanks

Boyan Silyavski
04-08-2016, 12:20 PM
Even so the best source to learn Mach3 is to read the manual (http://www.machsupport.com/wp-content/uploads/2013/02/Mach3Mill_1.84.pdf). Because even if sb is helping you, you have to understand the basic ideas behind all, in other words what's happening.

http://www.machsupport.com/help-learning/product-manuals/

RichardR
04-08-2016, 01:21 PM
Even so the best source to learn Mach3 is to read the manual (http://www.machsupport.com/wp-content/uploads/2013/02/Mach3Mill_1.84.pdf). Because even if sb is helping you, you have to understand the basic ideas behind all, in other words what's happening.

http://www.machsupport.com/help-learning/product-manuals/
Thanks
I am printing the manual as I type this, but as my post I will start to drop off before I am a few pages through it.
I managed to mill a test sign using the Write wizard, but only by trial and error, I would still like some one to one tuition