View Full Version : NEW MEMBER: Diy cnc

30-08-2016, 07:32 PM

I'm Dan and I'm from Milton Keynes. I have recently aquired a small 2 axis TEP CNC device which looks like it has a serial port for communicating with a PC. I think it's quite old (has 1999 written on it) and I can't seem to find software anywhere for it.

What I would like is some kind of CAD software where I can create a design and then effectively print it off. I want to steer clear of G code :culpability:.

I was thinking, if this is too old do do anthig with, I could perhaps relace the interface and drivers but still use the mechanics (stepper motors etc).

Could anyone either suggest some software for the existing TEP electronics or some replacement electronics and corresponding software (ideally free software :chuncky:)?

Any help would be much appreciated!