Can't Get my New Machine to work

[Kev2960]

Hi im still having problems getting my router working it's a 6040 with a 1500w motor. there doesn't seem to be any kind of a signal from Mach 3 to the machine,none of the motors have even tried to work. in the Mach 3 diagnostic's page port 1 pins current state are not light, is this correct. output signal 1 enable 1 is light.
there is a red stop led light on the control box If i disconnect the parallel cable this light goes off, any help would be appreciated 205852058620587

[John S]

Right we now know what a PRT E1500W is. It's the inverter for the machine and not the control box.

Did they supply a Mach setup file with the machine. It should end up blar-blar.xml ?
If so you need to copy this into the Mach3 folder and when you start up, use the icon that says mach3 Loader and select that name.
Try that and let us know.

Where in the country are you ? Someone may be local to you.

[Doddy]

A really obvious question, if none of the motors have worked. The E-Stop isn't depressed, is it? (once pressed it'll lock in place and stop any motor turning - reset by rotating the mushroom knob clockwise). I know it's obvious, but look at the simple things first.

[Kev2960]

Thanks John they didn't supply an xml file just step by step set up of ports and pins, motor etc which I've done and rechecked
I'm in Rugby CV211QB post code I'll see if I find the files
Thanks Kev

[kingcreaky]

I'm just down the road nr Hinckley if your still stuck tomorrow l can pop over if you like.

[Kev2960]

Hello kingcreaky, that would be brilliant thank you so much, if

[Kev2960]

Sorry I got distracted, if we swap emails I'll send you my address
[email protected]

[Clive S]

Kev it's not a good idea to show your email on the forum because of spamming. PM is better

[Kev2960]

Thanks Clive I'll bear that in mind for next time

[magicniner]

Thanks Clive I'll bear that in mind for next time

Edit your post and remove your address unless you intend to bin that one, otherwise bots will harvest the email address for years to come for addition to spam lists

[Cncest1925]

Hello, I have the same cnc 6090 machine. I completed the mach3 software install today I got the spindle running manually. I ordered the cnc from ebay came from China & there are no directions or manual that it came with. I found someone online with the same machine with the ports & pins settings. I cannot get the x / y / z axis to move at all.

Any help will be greatly appreciated!!!

Thank you

[Clive S]

Hi Cncest1925 and welcome to the forum.

You need to give more info some good picture of the inside of the control box and screen shots of your Mach3 settings would help.

These machines may look the same but the internals can be different.

[JAZZCNC]

Here's a few things it could be.?

If using a parallel port then mach3 won't work with the 64Bit operating system.

If USB then you'll need manufacturers controller Plug-in for Mach3. Without it, you'll never get it to work.

If using a laptop with a parallel port, not all will work with mach3.