PDA

View Full Version : RFQ: Ali plates 100x150x2 mm



cropwell
19-07-2017, 12:40 PM
I need half a dozen plates cut by 1st week in August. They have about 380 3mm holes drilled. Can anybody help me ? Preferably in the Nottingham/Derby/Leics area. Contact me and I will sent you a dxf file.

My own machine is still down after the computer went on the fritz and I lost all my software and setup. Even the Mach3 licence file has disappeared and my backups are not readable (GRRRR !!!:crushed:)

PM me if you can help, please.

Cheers,

Rob

cropwell
19-07-2017, 09:09 PM
Massive relief - Mach3 Support have a record of my licence so they sent me a licence file - now I just have to set up my machine again (from scratch)! Estlcam v10 installed and licence applied OK. AutoCAD reinstalled and registered, so have all I need to start up again (except energy :fatigue:)

Cheers,

Rob