View Full Version : Denford Triac VMC Mill with ATC, SERVO drives

Ade taplin
01-08-2017, 01:00 PM
Hi all,

I have just obtained a 2000 - 2001 mill from a training school, once installed at home and wired in (240 volts) there is no sign of life at the monitor but I get a green LED on the floppy drive but that's about it. There is power going to the monitor but no sign of a signal. The batteries on the DSP board are dead they only measure 0.02 volts I've ordered new batteries. Does anyone have any advise they can give me or am I looking at a conversion, if I need to convert it has any got experience with this machine as it has servo drives not steppers.

Any help is gratefully appreciated.