PDA

View Full Version : UHU Servo Controller build



Agathon
15-08-2017, 01:35 PM
I need an step/dir to +/-10v servo controller. I came across this http://www.uhu-servo.de/servo_en/index.htm which looks like an economical solution to the problem. However, while I have a basic grasp of electronics and can knock-up a power supply, I'm not capable of tackling a project like this without assistance.

I wasn't able to find a a simple circuit diagram and a component list on the site - basically I need idiot-kit instructions. Has anyone on here built one? Any help very much appreciated.

David

Agathon
15-08-2017, 01:45 PM
I should have said that I need to control analogue AC servo drivers - so not sure if the UHU controller is suitable at all.

Ger21
15-08-2017, 03:40 PM
Read the first line of the FAQ: http://www.uhu-servo.de/servo_en/UHU%20FAQ_en.pdf
For brushed DC motors.

Agathon
15-08-2017, 03:45 PM
Read the first line of the FAQ: http://www.uhu-servo.de/servo_en/UHU%20FAQ_en.pdf
For brushed DC motors.

Yes, I was living in hope that they might provide signals for AC types too.