2.2 KW 3 Phase Induction Motor

[Chaz]

A bit of a long shot, does anyone have a Harrison M300 motor that I can buy? Mine has packed up and struggling to find an exact equivalent.

2.2KW (3HP), 4 pole, Star and Delta wiring. 90 sized frame, 24mm shaft.

Thanks

[m_c]

Have you got any machine you've not managed to break? :-)

Inverter Drive have one option available to order- https://inverterdrive.com/group/Motors-AC/?filter=Frame%7c90%2cPower%7c2.2kW&filter=Speed%7c4+Pole+1500RPM

[Chaz]

Have you got any machine you've not managed to break? :-)

Inverter Drive have one option available to order- https://inverterdrive.com/group/Motors-AC/?filter=Frame%7c90%2cPower%7c2.2kW&filter=Speed%7c4+Pole+1500RPM

Nope, seems not.

Thanks, had seen that, bit pricey but OK. Thoughts on installing a higher power motor? I might call a supplier this morning and if the 100 frame motor is only marginally bigger, I might go this route with a new pulley.

Mmmm. That is a face mounting motor, so wont work without mods to the install.

[magicniner]

Mmmm. That is a face mounting motor, so wont work without mods to the install.

Face mount to flange or foot mount is just a set of parts, the supplier should be able to supply or fit a foot mount kit at minimal cost, my motor supplier has a price for a given spec of motor and supplies foot, face or flange at the same price or the parts to swap it over.

You could share with the class where 3 phase motors are available cheaper if you have a source of good quality units for low prices? :-)
Regards,
Nick

[Chaz]

Face mount to flange or foot mount is just a set of parts, the supplier should be able to supply or fit a foot mount kit at minimal cost, my motor supplier has a price for a given spec of motor and supplies foot, face or flange at the same price or the parts to swap it over.

You could share with the class where 3 phase motors are available cheaper if you have a source of good quality units for low prices? :-)
Regards,
Nick

Example - https://www.sdsdrives.com/products/motor-control/Motors/AC-Induction-Motors/Standard-TEC-MS-IE2-AC-Motors/TEC-MS-IE2-AC-Motor-22kW-3PH-230400Vac-4-Pole-2243TECAB3-IE2

Price probably excludes VAT (not sure if the other one does or not). Motor size is OK, frame size a bit larger. So If I can modify a pulley and basically the rest works, this might be the way to go. In which case going with a 3KW 100 frame motor might be OK then?

[Chaz]

Managed to get a 3KW motor (100 frame size) from a colleague at work that has some machining stuff.