PDA

View Full Version : FOR SALE: CNC4U 3 axis system



emlclcy
24-11-2017, 03:09 PM
HI
a while ago I built a 3 axis system using a 10" x y table and a water cooled variable speed spindle. all the parts came from cnc4u except the x y table.
it all works and I made a couple of projects but ive gone back to manual so its all up for grabs if anyone's interested.
contact me if you are and I can list all the components
cost a bl**dy fortune to build!
cheers
carl

Leadhead
24-11-2017, 05:26 PM
Could you pm me with the list and most essentially the price if you would please.

emlclcy
20-12-2017, 08:18 PM
Hi,
sorry its taken so long to fill in the details

control unit mounted and wired in a funky acrylic clear box, comes with all the leads.
I have a licensed copy of mach3 not sure how to transfer the license tho

cnc4u part codes
CP0-10V breakout board
UC300-USB
CWD556 stepper controller 3
36V 11A 400Watt PSU
plus relay board to switch mains to control water pump, spindle & 1 spare. emergency stop no volt switch and z axis stop jack

the xy table is made by NEAT, it is solid billet ali and weighs about 15kgs, it has 8" travel, the table is 10" square. The lead screws have a 2mm pitch. All the bearings are adjustable for backlash, at the opposite end to the stepper motor there is a dual ball bearing configuration that you pre load them against each other

open to offers


some pictures I hope

carl

Leadhead
27-12-2017, 12:37 PM
Can I assume you have lost interest in selling this?

emlclcy
29-12-2017, 09:32 AM
this is the spindle mounted on a zero backlash ballscrew. It comes with a water pump and variable speed controller. all bought from cnc4u as a system so designed to work together. also a set or er20 ncollets, some unused.
It has a Microsoft webcam with upgraded optics for zero location that works with mach3
z axis limit switch.
It all works fine and has hardly been used
open to offers

emlclcy
29-12-2017, 02:58 PM
this is the spindle mounted on a zero backlash ballscrew. It comes with a water pump and variable speed controller. all bought from cnc4u as a system so designed to work together. also a set or er20 ncollets, some unused.
It has a Microsoft webcam with upgraded optics for zero location that works with mach3
z axis limit switch.
It all works fine and has hardly been used
open to offers

sold

emlclcy
29-12-2017, 03:01 PM
£200 for the x y table + controller

petesurrey
01-01-2018, 12:01 PM
£200 for the x y table + controller

Where about are you located? I am interested in the controller.

Thanks

Peter

emlclcy
01-01-2018, 01:27 PM
Basingstoke

petesurrey
01-01-2018, 02:16 PM
Ok PM sent

emlclcy
02-01-2018, 12:52 PM
all bits sold