PDA

View Full Version : NEW MEMBER: New guy from Tunbridge UK



Malamute
07-08-2018, 08:23 PM
Hi guys, I am looking to build a plasma cnc table. I currently have a Hypertherm 45xp with hand torch and a Lincoln Electric PC210 which I use when I dont need to cut thick metal. I know I will need to buy a machine torch for the Hypertherm so no surprises there. I have watched some vids on youtube but as yet I have not done a lot of research into it. Ideally I would like to build a table which is 4 foot by 2 foot due to limited access.

Are kits readily available to buy to build your own ? I could of gone out and spent 7 or 8k on a ready built machine but I think I could build a better one for less, at least if I build it I will know how to fix it when it inevitably goes wrong.

Regards Malamute