Schematic question wiring Am882 ALM Alarm, Limits and Security Relay Pilz S5 ?

[pierantoine]

Hello,

I'm trying to wire the AM882 Fault Alarm ALM on my system,
the latch reset and e-stop already works.
The Pilz S5 has 2 inputs, i'was thinking using on input for the limits and one for the am882 alarm, but when one of the 2 input signal is open the relay goes in Fault (red light) and it must be reset by removing the relay supply... 'maybe a problem of setup mode ?

or 2 I could wire the alarm in series on the estop circuit from the 24v to the inputs of the s5 but adding 3 or 4 inductive proximity sensor in series could be a problem with the maximum 100mA on the AM882 alarm.

Do you have an idea ?

Thanks for your help...

24762

[pierantoine]

Hello,

I'm trying to wire the AM882 Fault Alarm ALM
I could wire the alarm in series on the estop circuit from the 24v to the inputs of the s5 but adding 3 or 4 inductive proximity sensor in series could be a problem with the maximum 100mA on the AM882 alarm.

Do you have an idea ?

Thanks for your help...

24762

Wiring in series the alarms to the relay input doesn t work...
Voltage drops from 24 to 8v...

[Nickhofen]

Have you check this thread?
http://www.mycncuk.com/threads/5566-Wiring-up-the-Alarm-output-on-Leadshine-AM882

[pierantoine]

Have you check this thread?
http://www.mycncuk.com/threads/5566-Wiring-up-the-Alarm-output-on-Leadshine-AM882

Yes. Thanks.
But the problem is my 24v after the driver is dropping to 8v when driver is in fault state... And connected to the input of the pilz.

[pierantoine]

Hello
I ve still the problem of connecting the am882 alarm with a pilz if you have an idea it can help

Thanks

[Nickhofen]

I am sorry to hear that, I hope the help come soon!

[EddyCurrent]

Have a look here;

http://www.mycncuk.com/threads/6565-Ready-Steady-Eddy?p=52213#post52213

Then I found the alarms were wired incorrectly and changed it here;

http://www.mycncuk.com/threads/6565-Ready-Steady-Eddy?p=57622#post57622

This all works well now.