terry1956
18-11-2018, 03:56 PM
Hi chaps. I am trying to wire up the CSMIO/IP-M board. and I am not getting very far. I cant read the wiring diagram on the net as its to small and when I try to print it larger it just looks like a lot of dots. so these are my questions
1. do I need the input terminal block connected if I am using the ethernet cable ???
2. on the outlet side terminal block how do I know which number on the block goes to which input on the stepper motor driver.
3.do I need to use the Estop unit at all, can I loop it for testing on the worktop. is so how. I don't understand how this connects to the CSMIO unit,
4. from what I have read I need to add a plugin to mach3 to make the CSMIO work. is this correct and how do I do that.
sorry for all the questions.25127251282512925130
1. do I need the input terminal block connected if I am using the ethernet cable ???
2. on the outlet side terminal block how do I know which number on the block goes to which input on the stepper motor driver.
3.do I need to use the Estop unit at all, can I loop it for testing on the worktop. is so how. I don't understand how this connects to the CSMIO unit,
4. from what I have read I need to add a plugin to mach3 to make the CSMIO work. is this correct and how do I do that.
sorry for all the questions.25127251282512925130