PDA

View Full Version : Profile and 3D Clip-art HELP...



CrazyFloridian
25-03-2019, 03:33 AM
If I pick a 3d clip art object and place it down, run a roughing tool path it takes like .45 of material away around the object before it starts the roughing and finishing tool paths, why is that?

see pic,

m.marino
13-04-2019, 07:11 PM
Depth that you place the object at is in the toolpath control section. best bet is go watch the Aspire videos as they do a very good job of explaining it. If you don't get a good grasp of it there, I would go on the vectric forum and ask there as you will get a much better explanation from the folks there. I use Aspire9.5 and while I am good at using it i am not the greatest at teaching it.

Michael