Mach 3 - Spindle Control

[myles.merry]

Hi Guys,

I need some help setting up the spindle relay on the software as i cannot get the relay working

Thanks,

Mykles

SOLVED LOCKED.

[Doddy]

You might find a constructive response if you provide a bit more info.

Peering into my crystal ball, I'd ask where the relay is (BOB?), whether you've got an output under Mach3 assigned to the corresponding pin on the BOB and then whether you'd transferred the output number into the Spindle control page on Mach3. Damned crystal ball is all foggy.

[myles.merry]

Thanks i have worked it out!

[cropwell]

In the spirit of this forum, it would be nice to know what the problem was and how you solved it! Just to help others (that's what we are here for).