5 axis breakout board and UC400eth query

[Palletlad]

I am redesigning my control box as after learning a bit more discovered a few issues I was previously unaware.
I have the standard £5 5 axis breakout board and using the UC400eth as well, my question is I power the BoB via USB 5v input, can I then connect the UC400eth to the PC5v and PC GND connectors on the BoB to power it also as at the moment I have a dedicated 5v PSU.

I currently have 48v PSU for the stepper drivers, 24v PSU for the pump, fans and spindle controls on the BoB, 5v PSU for the UC400eth

I am aiming to separate the VFD as was originally in the control box and also the pump.

[Ger21]

The UC400ETh requires a 12V-24V supply, not a 5V supply.

[Palletlad]

You just pointed something out I misread, the uc400 has a step down on board so a 12v24v can be used but it only requires 5v. I misread this when I first got this and been using a dedicated 5v psu for it with no issues, I now no longer require the 5v psu in my set up. Thank you for pointing this out I just made some more space in my box.