PDA

View Full Version : Rubber/plastic flexible strip for swarf exclusion



Voicecoil
09-09-2019, 11:41 PM
Any ideas what this stuff is called (often seen on Stepcraft machines) and where you can get it from please?

26422

Nealieboyee
10-09-2019, 12:15 PM
26428

I believe motedis and ooznest sell this type. Probably eBay too.

RS components has a range of dust cover strips too for different width slots.

Voicecoil
10-09-2019, 06:35 PM
Neal - thanks for the reply, but those aren't quite what I'm looking for. The Stepcraft machines have the gantry side plates running in a slot with a flexible rubber(?) strip either side to stop swaft getting down into the ballscrews, guides, belts whatever, sorry the photo's not very good. I've looked at rubber draught excluder strips, but all I've seen so far are a bit on the stiff side

John McNamara
11-09-2019, 12:27 AM
Hi Voicecoil

https://jehbco.com.au/

This company will have the extrusion you are looking for.
It can be rolled up and posted

Regards
John

Voicecoil
11-09-2019, 09:36 PM
Thanks John, I hadn't thought of silicone, I was expecting polyurethane or natural rubber from the abrasion resistance angle.

cropwell
11-09-2019, 10:54 PM
https://www.polymax.co.uk/rubber-sheet/sponge-epdm-neoprene-foam-strips-sab

Any use ?

m_c
12-09-2019, 12:52 AM
I know the kind of thing you're after, however I've got no idea what it's official name is, let alone where you can buy it.

A bigger rubber version is often used on roller/shutter doors, but the thinner harder plastic version is fitted to some 2 post car lifts.

Voicecoil
12-09-2019, 01:04 AM
Yes, flexibility is the key, so it will mould/seal itself around the moving bits. I've used slider potentiometers/faders on audio and lighting control desks in the past that have had a thinner version of this stuff covering the actuator slots but it came as part of the unit from the Far East.