itbookham
10-11-2009, 12:18 AM
Hello,
I am new to this Forum and would like to say hello to everyone.
I am very much a hobby machinist. My small workshop houses a Chester Conquest lathe and a Sieg X1 mill.
At the moment I am working on a 2" Clayton Steam Wagon.
I have been toying with the idea of setting up CNC on the lathe and mill. I would be grateful for advice and suggestions on whether it is practical on these types of machines.
Many thanks for listening.
Regards,
Mark
I am new to this Forum and would like to say hello to everyone.
I am very much a hobby machinist. My small workshop houses a Chester Conquest lathe and a Sieg X1 mill.
At the moment I am working on a 2" Clayton Steam Wagon.
I have been toying with the idea of setting up CNC on the lathe and mill. I would be grateful for advice and suggestions on whether it is practical on these types of machines.
Many thanks for listening.
Regards,
Mark