PDA

View Full Version : Heart shaped trinket box



CharlieRam
21-11-2020, 07:41 PM
My first attempt at cutting oak. Just a little something for my girlfriend from a few offcuts of oak, I must say it cuts really well. The box was modelled using vcarve and I created a 3d printed jig for holding the heart lid while profiling the top.

https://uploads.tapatalk-cdn.com/20201121/d386bcc17bbd081b30cafbadf0f46993.jpghttps://uploads.tapatalk-cdn.com/20201121/1554da01d93d84bd857ad9a6969024c5.jpghttps://uploads.tapatalk-cdn.com/20201121/40b8fa62a18d0482f1f86354b3c7075e.jpghttps://uploads.tapatalk-cdn.com/20201121/fe13b61cdd269eeaa3fc65062aef5f74.jpg

Sent from my M2003J15SC using Tapatalk

JAZZCNC
21-11-2020, 08:34 PM
Nice work Charlie.:applause:

But whatever you don't put a ring in that box and get down on one knee otherwise it will be the last Oak you cut..:smiley_simmons:

CharlieRam
21-11-2020, 08:48 PM
Cheers Jazz, there's no danger of that happening....I learned the hard way [emoji16]

Sent from my M2003J15SC using Tapatalk

Emma_smith
25-11-2020, 06:58 PM
Holy Cow!
That's an amazing piece :0
I love this project showcase section only because of this beautiful and innovative work. Keep going :)