PDA

View Full Version : question ...



Wobblybootie
03-01-2010, 10:52 PM
I read a thread not too long ago where a link to a Router build using epoxy between the frame joints was posted, for the life of me I cannot find it again. Anybody any ideas? (That will teach me to bookmark the snippits of info I want to re-read)

irving2008
03-01-2010, 11:04 PM
there was a discussion in the thread 'opensource design' (http://www.mycncuk.com/forums/showthread.php?1477-Open-source-group-project-anybody-interested&p=9706&viewfull=1#post9706) on this, but i dont recall a specific thread on the subject... there are some on CNCZone tho

Wobblybootie
03-01-2010, 11:11 PM
Hmmm, I remember that the link led to a site that belonged to an American guy, he built a huge steel framed machine and he used an epoxy type stuff between the joints and he also used it in combination with a surface table to put a flat layer on theframe members his linear rails were bolted to.

irving2008
03-01-2010, 11:21 PM
There was this thread on CNCZone (http://www.cnczone.com/forums/showthread.php?t=55625)

Wobblybootie
03-01-2010, 11:26 PM
You are a Star ... that's the one ... I have marked it now, so I will not go asking daft questions again.

Many Thanks

audioandy
03-01-2010, 11:32 PM
There is this guy from the Uk
http://www.cnczone.com/forums/showthread.php?t=30751

Andy

Wobblybootie
04-01-2010, 12:04 AM
Yep got it ... thanks.