View Full Version : NEW MEMBER: Hi to everyone
14-02-2010, 11:03 PM
Hi to all at mycncuk, looking to get started building soon, background in electronics, pcb design and make, (manual and cad). Looking for a few inexpensive stepper motors to play around with, i intend to control them using pic (picaxe) micro. based in glasgow, anyone near by that i can purchase some surplus motors from, i'd be glad to travel and collect if it's not to far.
Thanks in advance, Wildbill.
14-02-2010, 11:14 PM
Hi bill, i'v got 3 motors that have seen very little use if you would like them?
Welcome to the site!
14-02-2010, 11:31 PM
Hi Lee, thanks for the response. i have started building the gantry and table, 100cm X 50cm table, i have also made some linear bearings, so i guess the motors need to be quite small, i intend using a small (850 watt) router or a dremmel. I'm reading some stepper theory and i will build the drive board (not for cost reasons but because i enjoy doing stuff !!). What size are your motors and what cost ? do you think they would be suitable give the sizes mentioned above ?
15-02-2010, 12:26 AM
Hi i will send you a PM with the info on the motors now.
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.