View Full Version : Number plate dies and a Sieg KX3 CNC Hobby Mill
12-04-2010, 10:36 PM
12-04-2010, 11:16 PM
I presume you mean a pair of dies in steel for stamping ?
Click to enlarge.
If so then the KX3 will have no problems doing this.
13-04-2010, 10:54 PM
in a vector format etc thanks again
13-04-2010, 11:15 PM
The Mach3 software won't do drawings, it's the controller software for the machine and reads G code that's been done by another program.
I did the two 'nearly' matched sets last night in Vectrics, VCarve pro.
I just used a font and made one female and one male but in real life the male one has slight radii in the corners equal to the tool radius.
To work as a set of stamping dies the female one will need the same radii so it presses and not cuts.
I could do the programming if needed.
14-04-2010, 04:42 PM
thanks again for any help cheers Patrick
14-04-2010, 04:51 PM
hi i am wondering would the kx1 do the same job for me as its abit cheaper and i dont need any bigger sizes thanks for you help john
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.