View Full Version : RFQ: Write a program for me - Steel Dies
05-05-2010, 07:03 PM
hi i have been looking into getting steel dies made and i have come to the conclusion that i could make the dies on a kx3 if i could get someone to write the program for me as im a novice in 3d but have loads of experience in 2d drawings etc any help or guidence would be greatly appricated thanks
05-05-2010, 08:18 PM
Do you have any drawings/photo's/sketch's that you can post to give us an idea of what you are after.
Do you have a KX3 already? if so what tooling do you have available for it?
06-05-2010, 10:31 AM
i will be getting a set of dies with the outside measuremnets the same but with different inside fonts etc i will post a picture of what i mean. the link is for a company that used to make them but dont anymore. i dont have a kx3 as of yet but my local supplier is going to allow me to use it to see if it will do my job ok. As for the tooling i dont know what tooling i should be using etc thanks in advance Patrick2123
07-05-2010, 12:23 AM
ive downloaded a demo of v carve pro and you can import the fonts straight into it . i just wouldnt know where to start with making the 3d with radius etc . hopefully i can get this problem solved soon thanks again
29-05-2010, 03:07 PM
hi this is what i am after i will provide more detailed drawings if i can get someone to take this job on thanks in advance Patrick2214
29-05-2010, 03:15 PM
29-05-2010, 03:25 PM
Patrick emails to you keep bouncing.
29-05-2010, 06:52 PM
hi sorry about that john my email address is either : email@example.com or firstname.lastname@example.org i would like to hear from you thanks again Patrick
29-05-2010, 11:55 PM
Patrick, check both emails again please.
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.