View Full Version : WANTED: 11" Harrison
21-06-2010, 10:57 PM
I need a feed shaft for my 11" Harrison 40" between centres. The one that drives the auto longitudenal feed. The lathe has a Norton type gearbox. Has anyone any suggestions where I might buy one?
21-06-2010, 11:10 PM
Isn't it just a straight rod with a keyway in it ?
24-06-2010, 09:51 PM
As far as I know yes it is a straight shaft with keyway but as mine has either been broken and removed or at some time simply removed I have no idea what it should look like at each end nor do I know what diameter it should be. What are your thoughts? If I had an engineering drawing of one I guess I could have one made but without that I need some one to tell me where to obtain either a new or used one. Many thanks for the reply
24-06-2010, 11:17 PM
Try emailing Tony at lathes.co.uk or try http://www.gandmtools.co.uk/makerspages/harrison.html
26-06-2010, 09:32 AM
I have alreaqdy contacted the obvious sources with no luck hence the request for help
Thanks anyway Irving2008
28-06-2010, 11:46 PM
Have you tried these fellows, they claim to hold all the drawings?
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.