Normsthename
23-06-2010, 01:33 PM
Hi
I am new to the site, I was pointed to it by another member (Chip)
My name is Andy and I am located in Leicester.
I have a homebuilt Plasma machine that I built about two years ago.
I did everything myself, designed it, built it and wired it :smile:
It started out as a CNC Router but I later converted it over to Plasma
It runs a Hypertherm Powermax 1000 and a Campbell THC 300 Torch Height Controller.
Here is a video of my machine for those interested :smile:
http://www.youtube.com/watch?v=Cn1Sgeo6jas
This is a picture of the Box electronics
2336
I hope to build a Mark 2 machine this Winter if funds are available :whistling:
It will have a larger bed size (2000 x 1000), lighter gantry and will also run a lot faster
Andy
I am new to the site, I was pointed to it by another member (Chip)
My name is Andy and I am located in Leicester.
I have a homebuilt Plasma machine that I built about two years ago.
I did everything myself, designed it, built it and wired it :smile:
It started out as a CNC Router but I later converted it over to Plasma
It runs a Hypertherm Powermax 1000 and a Campbell THC 300 Torch Height Controller.
Here is a video of my machine for those interested :smile:
http://www.youtube.com/watch?v=Cn1Sgeo6jas
This is a picture of the Box electronics
2336
I hope to build a Mark 2 machine this Winter if funds are available :whistling:
It will have a larger bed size (2000 x 1000), lighter gantry and will also run a lot faster
Andy