PDA

View Full Version : hiwin profiled rail



jonm
06-08-2010, 11:54 PM
irvine this may be one for you
would it be possible to use one 35mm profile rail and one bearing block on a z axis the block is 70 mm wide x 112

dynamic load for block is 49kn

just a thought

irving2008
07-08-2010, 12:41 AM
do you mean vertically? for a plasma torch?

Gary
07-08-2010, 09:12 AM
This would work, but a masive overkil, you could do the same with one HGR15 and HGW15

jonm
07-08-2010, 06:10 PM
irvine, gary
for a wood router

Gary
07-08-2010, 06:49 PM
It would be better to use two of the HGR15 rails.
The HGR35 would work, but it is better to keep the height of the rail as low as possible, so using two smaller rails would e better.

jonm
07-08-2010, 07:07 PM
gary
would two 15mm rails and one bearing per rail work

Gary
07-08-2010, 07:30 PM
For a plasma it would not be a problem, but a router it would be better to have two bearings per rail.

jonm
07-08-2010, 07:48 PM
gary
might just go for your 20mm rail kit