PDA

View Full Version : NEW MEMBER: Hello to all members



HUKBMBEAR
24-08-2010, 12:40 AM
Hi, by way of an introduction, my name is Ken, from Hull in England
I have just started looking at CNC as a way to expand my experiance with machine tools. So far I have built an X,Y,Z gantree and have hooked it up to a PC running Mach3.

As yet I have not attached a router, as did not want to go further if the set up had problems. Next step seems to be to learn how to use the Mach3 software. the machine works fine in manual control, however I am having trouble getting past first base in the creation of usable G-code.

Anyway thats me and where I am up to, I am hoping the forum can be of help with th issues that I am sure will now develope

Lee Roberts
24-08-2010, 12:52 AM
Hi Ken,

Welcome to the site, i think we should be able to get you all the help you need. Have a look in our Machine Control (http://www.mycncuk.com/forums/forumdisplay.php?93-Machine-Control-Software) forum, this is also the best place to open a new thread for all your problems with regards to the MACH3 software.

Thanks,
Lee

HUKBMBEAR
24-08-2010, 06:00 PM
Hi Ken,

Welcome to the site, i think we should be able to get you all the help you need. Have a look in our Machine Control (http://www.mycncuk.com/forums/forumdisplay.php?93-Machine-Control-Software) forum, this is also the best place to open a new thread for all your problems with regards to the MACH3 software.

Thanks,
Lee

Thanks look forward to exploring the network