Len-Tikular
15-09-2010, 10:35 AM
Hi,
Just found this super new site.
Hobies are of course CNC and engineering.
I have recently completed a flatbed 3 axis router using MAch3 which works realy well.
I now have a Starturn5 by Denford and want to convert it to run with my existing controller.
Hopefuly I will be able to assist as well as ask.
Best regards to all on board.
Just found this super new site.
Hobies are of course CNC and engineering.
I have recently completed a flatbed 3 axis router using MAch3 which works realy well.
I now have a Starturn5 by Denford and want to convert it to run with my existing controller.
Hopefuly I will be able to assist as well as ask.
Best regards to all on board.