View Full Version : Want to make a custom CNC controller box

30-09-2010, 09:46 PM
out of perspex? here's how to go about joining it up after initial layout and cuts.

Use a router and v groove bit,use the router on the slowest setting to stopthe bit welding to the perspex.

Quite neat way of doing it in my opinion....


30-09-2010, 11:47 PM
thats a nifty way.. might have to give that ago me sen!

01-10-2010, 10:41 AM
I thought so too,with careful planning out on a piece of paper first to see where the V cuts need be,we can make a one unit cover for things...say like an L shaped housing or a box that covers the side and back of something? the trick is to cut the V slots in the perspex at nearly full depth of the perspex leaving about 1/2mm for keeping it together before tape&snappage.