View Full Version : NEW MEMBER: "Hi" from Johannesburg

05-10-2010, 05:39 PM

I read an article by a chap who'd built a CNC plasma cutter, saw that he'd done it for about 200, and thought, and thought, and thought, and thought, then dropped in here.

Will an Ebay cheapo Chinese tb6560 board and some 13Kg 4wire steppers be enough to move a plasma cutter handset or a small router around on a 1.2 x 2.4m bed if I keep my friction loads down?

All the Best, Oz.

Lee Roberts
05-10-2010, 11:44 PM
Do not use this forum for discussions or asking questions. Please wait until you have been approved as a member and then post your question in the appropriate forum.

Hi and welcome to the site, we have some plasma builds in the build log section.

Your membership has also been accepted!