introduction newcastle-under-lyme

[rw3rw3]

Hi,

I have a small chinese miller (x travel 400mm, y 150mm, z 85mm) that I converted some years ago to CNC using unipolar Compucut system plus ballscrews. I am currently converting to bipolar using DIYCNC System4, Mach3 plus Kflop usb interface.

I am considering building a gantry router with a bed size of about 1200mm x 600mm.

Searching this forum has proved very useful in solving any problems that I have had.

Cheers
Rob

[Lee Roberts]

Hi,

Welcome to the site, your membership has been approved and you now have full access.

Please post your questions in the correct forums for the best assistance.

Lee