PDA

View Full Version : WANTED: Timing Pulley Suppliers?



m_c
09-09-2008, 09:39 PM
The last mechanical component I need to source for my z-axis is a 72tooth HTD 5mm pitch by 25mm wide, preferrably in alloy.

HPC do them at , RS only stock Gates (Gates use Cast Iron at that size), and I can't remember the name of the company usually recommended by the model engineering lot.

I also need a belt and a 24t for the motor, but they're easy enough to source.

Any suggestions?

Lee Roberts
01-11-2008, 06:37 AM
bump...............

Robin Hewitt
01-11-2008, 12:10 PM
Have you tried Huco? They're cheap for racks, not tried them for puleys

http://www.huco.com/products.asp?p=true&cat=318

Smiler
01-11-2008, 01:51 PM
http://www.bearingboys.co.uk/72-5M-25_Metric_Timing_Pulley-21264-p

in steel I'm afraid but any use?

m_c
02-11-2008, 01:02 AM
Oh, totally forgot about this.
I just went to HPC for the required pulleys. It's only for the one axis, and they had them in stock. For all the money I was likely to save, it didn't seem worth the hassle to try and get them else where.