View Full Version : NEW MEMBER: Cheap DRO using a USB interface

15-12-2010, 08:27 PM
Hello all,

I'm looking to build an interface between some cheap Chinese scales and a PC to use as a DRO. USB would be nice but I would settle for serial connections. I'm a VB programmer so once I get it on the PC I should be able to get the rest going.

If anyone has the interface built and needs VB programming to run it let me know and I'll try to work out a deal.

Any help would be appreciated. My mill is nearly impossible to read using the factory dials and I need a good DRO that I can count on.

Lee Roberts
17-12-2010, 02:42 PM

Welcome to the site, your membership has been approved and you now have full access.

Please post your questions in the correct forums for the best assistance.


17-12-2010, 03:39 PM
Try here:

17-12-2010, 05:10 PM
That will get me started. Thanks again for the info.