PDA

View Full Version : The cutting fun begins



m.marino
21-02-2011, 09:27 PM
Below are a few pictures of an acrylic mouth piece for harmonica that I cut on my mill. Fresh from the mill and only light finish trimming no surface polishing or the final flame polish on it yet.:naughty:

I have to say that I am feeling good about the results. Though I had to spend 4 hrs editing the G-code from BobCAD to get rid of redundant runs/ moves in the Gcode.:joker: Still needs a bit of refining but very close to what i was shooting for the second pic is the acrylic mouth piece next to the metal one that the design was based off of.:dance:

h4ppy-chris
22-02-2011, 12:32 PM
looking good mate.

Lee Roberts
01-04-2012, 01:35 AM
Any pics or updates of the finished harmonica ?