View Full Version : NEW MEMBER: Hello
27-05-2011, 01:31 PM
This is my first time. You guys must have heard my problem many times before and probably gone through it yourselves.I have just purchased a new cnc router, bought the software followed all the instructions but for the life of me I just cannot get my motors to move. I would greatly appreciate any help you can give me.
27-05-2011, 07:33 PM
Hi / welcolme
Post your question in the right forum if and when you can. It's difficult to answer without knowing what make/model your CNC router is?
If you can't get it going through the answers here give me a shout and i'll pop down and have a nose.
28-05-2011, 11:42 AM
I will try agin today with a new driver board. If I still can't get them going I would certainly appreciate yor help.
30-05-2011, 12:07 PM
I still have not had any luck I would like to take up your offer. Can you tell me how I can contact you.
I'll contact you this afternoon
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.