View Full Version : NEW MEMBER: Hello all

23-07-2011, 08:23 PM
I would just like to say hi

I am just about to start building a CNC with my son

I'm a bit green but not clue less

I did join CNCZone but after three post and over 70 members viewed each post and not one reply!! I'm not going back

I hope you can all help me on my way with the new project

I am going to build a CNC with Aluminium extrusion and ball screws

stepper motor will be Nema 23 263 oz

x axis is running on 20 mm stainless steel the rest will be 16 mm stainless steel

Aluminium is from a 45 profile and will be 40/80 light


25-07-2011, 06:24 AM
Hi Luke

Welcome to the forum :beer:

It might be best to start your own build log once you get started.
If you can post what you are thinking of doing before actually doing it, it might save you some time and most importantly money as there are many people on here that have "been there and done that" and will give you good sound advice.

Good luck with the build.


25-07-2011, 06:29 AM
Did'nt see the double post:rolleyes: I can see you already have a good few people giving you advice :smile: