View Full Version : newbie with a tool id question

02-10-2011, 10:13 PM
hi all, ive just registered to the forum

i do a little machining with work but nothing huge

recently a bought a job lot off tools, i knew what a lot of it was but im having trouble with a final bit

i think its a quick release collet tapping set up but im not entirely sure


the markings are as follows:

large main part/chuck

bison s3

the 3 collet sets

m22 16x12.5
m24 18x14.5
m27 20x16

ive googled it to to death but drawn a blank

thank you in advance and i hope someone can shed some light

John S
02-10-2011, 11:35 PM
MT4 taper with a capacity of M14 to M33 and the three tap holders are for M22, M24 and M27 possibly a tad to big for 6BA :smile:

See here.


03-10-2011, 06:16 AM
brilliant, thanks for the quick response:tup: