PDA

View Full Version : RFQ: Touch Probe - Lathe job



cooliced
15-11-2011, 11:09 PM
Hi all, im looking for somebody to make me one of these if possible...

to fit a 6mm collet for the sherline


http://www.youtube.com/user/OfisProPlus#p/u/16/pmnKU-EpvhI

Thank you

Stu:question:

Jonathan
16-11-2011, 02:37 PM
I can make you one of those easily enough - though I would machine it all without taking out of the chuck and turning round as that introduces runout. Make the nylon part first, oversize, then the steel ... push the nylon bit on then skim that and the rest to get it all concentric.

It would be better to have the end a larger diameter than the rest as otherwise any burrs on the part you're probing will touch first, making it less accurate.

cooliced
16-11-2011, 07:12 PM
That sounds very good.. could you pm me cast mate on this if you can

Stu